HS 146 Update MS2020

[Vc Ten]

I think there is something going on there. When I tried to stop pushback in the a310 this morning, it restarted again on its own, while I was sorting out pre taxi checks. Clicked on the pushback stop on the tablet, which it did, but on taxying off, there was no steering. Checking outside I still had a tug attached. Clicking on the tablet eventually got it to disconnect, where we were OK then

Dale

[TSR2]

Interesting aerodynamics

[Nigel H-J]

Well I tried push back at Heathrow via the pushback in MS and it worked well. Set my flight plan to Edinburgh, went through the whole checklist procedure but found that since I had not flown the HS146 for a bit forgot where all the relevant switches are but got there in the end.

Sadly the flight encountered a slight mishap when 100nm from Talla (no FMC for me thank you very much) went to make a coffee then back into the cockpit where I was met with You have overstressed the aircraft!!!!!!

Too tired to be bothered to go through all of that again, will retry tomorrow.

Regards
Nigel.

[Vc Ten]

Now if you had programmed the fmc with the route, You could have had popped to the pub for a pint before landing
I never have the crash detection turned on. Been there done that
Dale

[Nigel H-J]

Now if you had programmed the fmc with the route, You could have had popped to the pub for a pint before landing
I never have the crash detection turned on. Been there done that
Dale

Now he tells me!!

I thought flight simulation is supposed to be real, there again, think crash detection will be turned orft after this!!

Regards
Nigel.

[DaveG]

V2 update is now available from your JF account. Other vendors should be soon, Marketplace in a week or so.

Huge update this one. Includes the new UNS-1 FMS.

[TSR2]

I might actually switch the PC on tonight?

[Paul K]

The Easter sale and the release of Version 2 finally convinced me to buy the 146.

The only issue at the moment is using a rotary control axis for trim; all three trim settings immediately go to -100% if I even so much as touch one of the knobs on my Loupedeck. They can only be brought back to neutral by repeated pressing of the assigned buttons/keys. The 146 is the only aircraft that has this problem, and I see that others are having issues with runaway autopilot trim, which sounds like it's connected to my issue. I'll stick with the key/button assignments for now, and talk to JF about it in due course.

Other than that, a real beauty, and well worth the price. Hugely impressed.

[Aharon]

Other than that, a real beauty, and well worth the price. Hugely impressed.

Take screenshots!!

[Chris Trott]

It's a stream, but here's a good look at it from "Moosestaffa", a guy I hop on stream with quite a bit who streamed the new version Friday during FNO.

https://www.twitch.tv/videos/2111913122