Classic British Flight Sim

Nigel H-J wrote: should not really be on-line.

Nigel.

These are the settings I have presently though do have to ajust Scenery Complexity and sometimes Autogen Density depending on what aircraft I am flying and where but basically these settings stay as they are.

Scenery:

Terrain Mesh=81
Terrain Texture=High
Terrain Detail=Land Only (For Hong Kong)
Water Effects=None
Extended Terrain Textures=Unchecked
Special Effects Detail=High
Scenery Complexity=Very Dense
Autogen Density=Very Dense

Weather:

Cloud Coverage=Medium
3D Cloud Percentage=100%

Hardware:

Target Framerate=Unlimited
Transform & Lighting= Checked
Anti-alaising=Checked
Filtering=Bilinear
Mip Mapping Quality=4
Hardware-rendered lights=6
Global Max Texture Size=Massive

Hope this helps.

Nigel.

:think:

I thought Filtering was normally Trilinear?

Garry

That depends on your system capabilities, Garry. Trilinear gives better graphic but worse performance.

Sumpn for sumpn....as always...

Thanks Dan

TBH I don't know it's effect apart from being advised to use it.

Garry

Garry try Bilinear, you might find an increase in performance. Graphic wise I have not noticed all that much difference to be honest.

Nigel.

Thanks Nigel

FULL POWER....! ! ! FULL POWER....! ! ! GO AROUND....! ! !



Yikes..... :brick:

Near Engine strike at Kai Tak.......

Tony

You like to live dangerously then Tony!! :o

Probably the VC10 is better suited ........at least the engines are higher up and away from the wings!!

Nigel.