Page 15 of 21
Re: Peters Paints!
Posted: 22 Apr 2018, 20:51
by MilesMan
Re: Peters Paints!
Posted: 26 Apr 2018, 00:31
by MilesMan
OK, I think 20 Hornets is enough! Have just uploaded a Hunting President paint for Rob's Pembroke C54:
Re: Peters Paints!
Posted: 26 Apr 2018, 03:50
by Airspeed
I've always liked the look of the Pembroke, and I like the twin Alvinides sound file.
Will have to check the hangar and see if I need any more paints. Thanks Peter!
Re: Peters Paints!
Posted: 26 Apr 2018, 15:29
by robcarrich
Peter, that looks superb, you really are breathing new life into some old models.
The new Hornet paints bring it to a completely new level, just love the textures and weathering.
By coincidence I rolled the Pembroke out of retirement this very morning for a
low and slow flight around my new Netherlands scenery, just got to have that new scheme when its ready!
RobR
Re: Peters Paints!
Posted: 26 Apr 2018, 18:09
by FlyTexas
Beautiful paint on the Pembroke, Peter.
Brian
Re: Peters Paints!
Posted: 26 Apr 2018, 19:00
by MilesMan
Thanks Guys. The Pembroke is one of my favourites too and I got fed up with only having G-APMO to fly in civvies!
Rob I could not see the C54 on your site so you might have a few people asking for it now! I was going to ask about the Sea Prince but as the Pembroke was one of your FSDS creations I did not hold out any hope with you moving to Blender. No worries though!
Peter
Re: Peters Paints!
Posted: 26 Apr 2018, 21:52
by robcarrich
MilesMan wrote: ↑26 Apr 2018, 19:00
Thanks Guys. The Pembroke is one of my favourites too and I got fed up with only having G-APMO to fly in civvies!
Rob I could not see the C54 on your site so you might have a few people asking for it now! I was going to ask about the Sea Prince but as the Pembroke was one of your FSDS creations I did not hold out any hope with you moving to Blender. No worries though!
Peter
I had better put C54 back up, at the double!
No Sea Prince Peter, I cant even remember how to start FSDS!
Rob
Re: Peters Paints!
Posted: 27 Apr 2018, 04:32
by blanston12
robcarrich wrote: ↑26 Apr 2018, 15:29
Peter, that looks superb, you really are breathing new life into some old models.
The new Hornet paints bring it to a completely new level, just love the textures and weathering.
By coincidence I rolled the Pembroke out of retirement this very morning for a
low and slow flight around my new Netherlands scenery, just got to have that new scheme when its ready!
RobR
Hi Rob, I took the Pembroke out today and am reminded how much I liked it.
I did notice once tiny issue with the manifold pressure gauge in that it never reaches 15 even though the red-line is at 30.
I tested it in both FSX and P3D4 with the same behavior.
Re: Peters Paints!
Posted: 27 Apr 2018, 07:28
by robcarrich
Hi Rob, I took the Pembroke out today and am reminded how much I liked it.
I did notice once tiny issue with the manifold pressure gauge in that it never reaches 15 even though the red-line is at 30.
I tested it in both FSX and P3D4 with the same behavior.
Joe, you need to find a good optician if that's the only fault you can find
I do use the term "not accurate" when describing the models on my site.
But you are quite right the reading is low.
If you go into the aircraft cfg.file in the [piston engine] section find "max_design_mp= 100" change to this value.
By the way Joe, behaviour is spelt behaviour not behavior
RobR
Re: Peters Paints!
Posted: 27 Apr 2018, 07:40
by Filonian
robcarrich wrote: ↑27 Apr 2018, 07:28
By the way Joe, behaviour is spelt behaviour not behavior
RobR
I had never realised before that this forum was also educational.
Graham