Classic British Flight Sim

Never been able to get ACG's Duxford scenery AI traffic working in PrePar3D.
How do you get AI traffic working?

Thanks.

Works fine for me. Are you sure you're using the FSX native models & flightplans and not the FS9 ones?

I pulled my finger out and went through all the files.
Seems the installer was placing all the files into a ficticious FSX directory.
So I copied them all over into the PrePar3D installation and all now working.

Got an additional unusual problem. I get two Sally B's with her P51's (that's 2 x B17's and 4 x P51's) who all taxi out and dot heir stuff but I only have one AI sim object.
What causes the same AI to duplicate? I never see three or four Sally B's? Always two.

You must have duplicate ai flight plans.

Where would they normally live Dave?

DogTailRed2 wrote: ↑

08 May 2020, 09:18

Where would they normally live Dave?

Do you have Traffic Toolbox installed? if so, you should be able to display the file paths.

Traffic files are usually in scenery/world/scenery or the scenery folder for the appropriate add-on, but they could be in any active scenery folder.

Cheers Dave. I'll have a poke around.
I'm thinking of going for V5 now anyway as I have messed around some of the default areas a little.
This should hopefully clean out the duplicates.

GHD wrote: ↑

08 May 2020, 09:59

DogTailRed2 wrote: ↑

08 May 2020, 09:18

Where would they normally live Dave?

Do you have Traffic Toolbox installed? if so, you should be able to display the file paths.

Is that freeware? I'll check it out thanks.