Page 1 of 2
FSD C-17 texture problem.
Posted: 23 Oct 2006, 14:06
by buff
Hi Guy's,
I just bought the FSD international T38/C17 combo package (not bad value for just over £9!) but there is a problem with the c17, when I load it up the texture do this.....
It does this every time on every texture?????
Could anyone help me on this one????
Posted: 23 Oct 2006, 14:18
by Garry Russell
Hi Buff
Does zooming inn and out cure the problem?
Garry
Posted: 23 Oct 2006, 14:31
by buff
Unfortuantely not Garry, I tried this earlier :sad:
Posted: 23 Oct 2006, 14:34
by Garry Russell
Try setting the mip level in the FS settings to a higher level
Garry
Posted: 23 Oct 2006, 14:39
by buff
Will do
Cheers
I'll get back to you
Posted: 23 Oct 2006, 14:43
by buff
Garry,
No joy with the MIP settings, the textures were still very Blurry,
Posted: 23 Oct 2006, 15:46
by Garry Russell
I know it's a pain but have you tried re installing?
Garry
Posted: 23 Oct 2006, 15:52
by AndyG
I had similar problems with their C-17, ditched it and switched to Mike Stone's version in the end. For some reason I didn't bother contacting FSD customer support! :think:
AndyG
Posted: 23 Oct 2006, 16:08
by hinch
if you have it, get into DXTBmp and re-save the textures without mips!
Posted: 23 Oct 2006, 16:13
by Garry Russell
That's why I asked him about zooming in and out. If it is just mips on textures they usually clear a bit when you do that. This is why I wonder if it is something else. I had a similar problem with textures that were saved without mips and it turned out to be the mip settings in FS
Worth a try anyway Buff, but they seem awfully blurred to just be the saved with mips problem.
Garry
