I seem to be encountering a problem with adjusting the ADF frequency on David M's VC10 C1K. It's a while since I last flew this aircraft, so a few days ago I did a fresh download and install. I find I cannot adjust the decimals of either the ADF1 or ADF2 (hundreds and units are fine). The 'click spot' appears to be there, but nothing happens when I click. I don't have this problem with the civil VC10 (or any of David's other aircraft). I can't see any obvious explanation in the manual. Just to be on the safe side, I did another download and install, but with the same outcome.
Am I missing something very straightforward? I would be grateful for some advice from one of the experts.
Regards,
Andrew
VC10 C1K ADF Frequency
Moderators: Guru's, The Ministry
Hi Andrew
Yes, I checked and was getting that too.
That's been broke since December then. :redface:
I don't use the C1K much these days.
It was an easy fix & so if you want to download it again it should then work for you.
Make sure that the page lists the download file as VC10_C1K_PANEL_20070801.zip (updated 01Aug07)
If not, refresh the page until it does.
http://www.dmflightsim.co.uk/vickers_vc10.htm
That ADF problem will only affect people that have downloaded the C1K panel since December.
Cheers
David
Yes, I checked and was getting that too.
That's been broke since December then. :redface:
I don't use the C1K much these days.
It was an easy fix & so if you want to download it again it should then work for you.
Make sure that the page lists the download file as VC10_C1K_PANEL_20070801.zip (updated 01Aug07)
If not, refresh the page until it does.
http://www.dmflightsim.co.uk/vickers_vc10.htm
That ADF problem will only affect people that have downloaded the C1K panel since December.
Cheers
David
-
Andrew Page
- Chipmunk
- Posts: 5
- Joined: 28 Jun 2004, 11:09