DaveB wrote:I can't find a good shot of AMYO which shows that side. Unless you can find definite evidence to show it wasn't there on YO.. I'd leave it there.
With the earlier, smaller-lettered version (cramped between the cabin vents), "LONDON" was annexed with no repeat above the pax door either: http://www.abpic.co.uk/popup.php?q=1244717
So I'll have to remove them, although it's a bummer, since the large fuselage textures allow such fine letters without blurring...
@Peter:
Any plans on doing Channel's G-ANVU? http://www.abpic.co.uk/photo/1445427/
If not, I'd gladly take over, since all the "decals" needed are already made for this Heron, also waiting to get released:
Hi Markus. I won't be painting the Channel aircraft so you are clear to go on G-ANVU! I am trying to avoid any natural metal paints as it is easier to cope with shades of grey. BTW thanks for saving me the trouble of painting the Morton scheme - I had earmarked G-ANAN - I had enough of that with the FR Heron schemes!
I think it would be a case of 'repaint efficiency' (sorry: I'm german after all!) to go for both versions.
Let's see if I could get rid of that grey belly coating and get her shiny again...
After some minor last minute corrections (adding the rego's last two letters to the front gear door for instance), Morton's G-AMYO finally was uploaded to SOH (already available there) and BritSim.
MilesMan wrote:I know this probably wont be a shock, but my first paint is of a CAFU aircraft! Couldn't resist using the G-ANUT example! Uploaded to BritSim(available now) and Flightsim.com(probably available tomorrow).
Peter
Downloaded. Many thanks Peter
Graham
The early bird gets the worm, but the second mouse gets the cheese.
Yup, I'd not seen the YO shot when I posted that comment but I had when I posted at SoH Obviously, don't leave the small lettering there with photographic evidence showing it wasn't there. You could always do one of the Doves that did have the lettering unless you're dead set on doing YO. I think YO wearing the small London title is quite pleasing too
EDIT: I see you've uploaded it. Lovely job
Atb
DaveB
Oh dear. Bought this and it flies exactly as I would expect. No trim issues, various stages of flap cause the nose to rise or drop as I would expect to see. The stalls in clean and landing config are right, takes a little time to come out of the stall even with full power you really have to push the nose down, wing drop countered by rudder.
Don't seem to be able to fault it.
Using Saitek trim wheel, yoke and rudder pedals in P3Dv3.