Catalyst 7.2 for ATI

Nigel Edwards · Post by **Nigel Edwards** » 24 Feb 2007, 18:39

is out folks, better frames for my system on both FS9 and FSX.

Best wishes

Nige

Post by **Trev Clark** » 26 Feb 2007, 12:08

Nigel, Itried this but have no control centre (or anything else), I have now reset back to the old drivers...........phew :sad:

Quixoticish · Post by **Quixoticish** » 26 Feb 2007, 12:37

They seem to be a good, solid driver set. My only issue is that Anti-Aliasing won't work in FSX or FS9 for me unless I crack the Catalalyst AI up to it's highest setting.

DanKH · Post by **DanKH** » 26 Feb 2007, 12:39

Trev, have you tried to go into Start - All Programs - Catalyst control Center?

Myles · Post by **Myles** » 26 Feb 2007, 15:15

Trev,

I think I read that the control centre needs the .Net 2 framework - might that have been your problem?

Best,
Myles

Post by **Trev Clark** » 26 Feb 2007, 19:21

No, everything should have worked, perhaps I got a dud download. I might try again soon. The programme showed on the list but never came up when I requested it on the desktop

migeater0 · Post by **migeater0** » 26 Feb 2007, 19:29

I had exactly the same thing. Just rolled back, installed .NET 2.0 and went from there. All fine now!

Post by **Trev Clark** » 27 Feb 2007, 16:46

hmm.............I have net.2, but still had the problem :think:

Post by **DaveG** » 27 Feb 2007, 19:19

Took me several attempts to get it to install properly too.
Here's what I did for a successful install:

Uninstall the original drivers using ATI's own uninstall prog. (should be in your start menu).
Reboot into safe mode.
Cancel any Windows "found new hardware" messages.
Run "Driver Cleaner Pro 1.5" and remove anything ATI. (http://downloads.guru3d.com/download.php?det=745)
Run "Windows Installer CleanUp Utility" (http://support.microsoft.com/kb/290301)
Reboot into Windows as normal.
Run 7.2 installer.