Having just done a fresh install of FS9, I'm slowly going through putting back all of the add on files.
After installing AFCAD updates to airports, aircraft act like a kangaroo on a pogo stick whilst on the runway (taxiways are O.K.).
I believe it's possible to 'Flatten' parts of the scenery. Can I do this with AFCAD2?
If not, how can I stop the bouncy effect?
Regards
Kevin
Bouncy Bouncy Runway
Moderators: Guru's, The Ministry
- Kevin Farnell
- Vintage Pair
- Posts: 2083
- Joined: 26 Jun 2004, 13:29
- Location: Willingham, Cambridge UK.
- Contact:
Kevin, Yes you can flatten using AFCAD, make a seperate taxiway along side your runway exactly the same dimensions and heading then use the move/drag n drop to move the taxiway under the runway, fault finder will tell you there is a unconnected taxiway etc which yo can ignore.
Got that off the net Opa Marshall's tips and tricks for AFCAD
Got that off the net Opa Marshall's tips and tricks for AFCAD
Rich
- Kevin Farnell
- Vintage Pair
- Posts: 2083
- Joined: 26 Jun 2004, 13:29
- Location: Willingham, Cambridge UK.
- Contact:
- Motormouse
- Concorde
- Posts: 1341
- Joined: 09 Sep 2004, 22:03
- Location: In a Hangar
- Kevin Farnell
- Vintage Pair
- Posts: 2083
- Joined: 26 Jun 2004, 13:29
- Location: Willingham, Cambridge UK.
- Contact: