P8 Compass in FSX

Classic British Flight Sim forum.
Support for Maltby/Piper FS models & other Classic British freeware.

Moderators: Guru's, The Ministry

Post Reply
JohnWillimas
VC10
VC10
Posts: 514
Joined: 26 Oct 2004, 08:28
Location: Near Daventry, UK

P8 Compass in FSX

Post by JohnWillimas »

I have a puzzle with the P8 compass in FSX.

I have this problem with the Chipmunk and the Beaufighter as well as the Just Flight Tiger Moth. This picture shows the Tiger's P8 compass in FS9 on Runway 24 at Duxford.

Image


As can be seen the compass points accurately points to the correct bearing, the cross piece indicating the aircraft's tale pointing away from the bearing.

However, loading up the same aircraft at the same location in FSX gives this result.....

Image

The compass appears to be pointing at 300 degrees. Is this a known problem with FSX????

Any thoughts welcomed.

User avatar
Rick Piper
The Gurus
Posts: 4776
Joined: 18 Jun 2004, 17:20
Location: In front of screen learning 3ds max :/ ...............Done it :)

Re: P8 Compass in FSX

Post by Rick Piper »

me again

i think you might be missundertanding how it works looking at those shots.

you need to turn the compass bezel till the N lines up with the Pointer indication north then take your bearing from the lubber line.

it's manual and won't read correct till you adjust it to match North.

Regards
Rick

hope this makes sense ?????

Image

User avatar
Bridon Bear
The Ministry
Posts: 1008
Joined: 26 Jun 2004, 10:30
Location: Cheltenham Gloucestershire
Contact:

Re: P8 Compass in FSX

Post by Bridon Bear »

Nicely explained Rick....... :thumbsup:

However on your original post John....You are in FS9 lined up as you say on runway 24 at Duxford....have you noticed that your actual heading is shown in red at the top of the screen as 293 Degrees (unless my eyesight is getting much worse... :worried: )

Could be a scenery placement error thrown into the mix perhaps...?

Regards

Bridon Bear
Image


'Only Birds and Fools Fly'

http://thethriftysquirrels.co.uk

JohnWillimas
VC10
VC10
Posts: 514
Joined: 26 Oct 2004, 08:28
Location: Near Daventry, UK

Re: P8 Compass in FSX

Post by JohnWillimas »

Rick Piper wrote:me again

i think you might be missundertanding how it works looking at those shots.

you need to turn the compass bezel till the N lines up with the Pointer indication north then take your bearing from the lubber line.

it's manual and won't read correct till you adjust it to match North.

Regards
Rick

hope this makes sense ?????

Doh!

Thanks Rick, you are right I was misunderstanding it. That's fine now.

JohnWillimas
VC10
VC10
Posts: 514
Joined: 26 Oct 2004, 08:28
Location: Near Daventry, UK

Re: P8 Compass in FSX

Post by JohnWillimas »

Bridon Bear wrote:Nicely explained Rick....... :thumbsup:

However on your original post John....You are in FS9 lined up as you say on runway 24 at Duxford....have you noticed that your actual heading is shown in red at the top of the screen as 293 Degrees (unless my eyesight is getting much worse... :worried: )

Could be a scenery placement error thrown into the mix perhaps...?

Regards

Bridon Bear
Thanks BB.

I think this was compounding the confusion. I fired up FS9 again - this time the heading is right and the compass work in both FS9 and FSX as Rick describes it.

:welldone:

User avatar
Rick Piper
The Gurus
Posts: 4776
Joined: 18 Jun 2004, 17:20
Location: In front of screen learning 3ds max :/ ...............Done it :)

Re: P8 Compass in FSX

Post by Rick Piper »

Hi Guys

I know it's a bit fiddly as Peter McLealand guided me through how it works as he pointed out that the M$ original was reversed if you use it properly.
I would never have noticed unless he told me but i know the Chipmunk V3 one works properly as Peter and I spent a few days of testing to get it correct.

Regards
Rick

Post Reply